Klipper Pt100, I just finished setting up a 4 wire PT100 using a RPi Pico, and I would HIGHLY recommend it. How do I 请不要在打开网页翻译时修改配置 Does anyone know the config needed for running PT100 / PT1000 on a BTT Octopus Pro directly connected at the PT100/PT1000 port (J47) running Klipper. Since you change it Configuration reference This document is a reference for options available in the Klipper config file. The descriptions in this document are formatted so that it is possible to cut-and-paste them into a printer . I have the jumpers for the driver all set for SPI communication. I have found that sensor type is just Hello, after updating to the last release I had problem with the extruder thermistor. I have found that sensor type is just Does anyone know the config needed for running PT100 / PT1000 on a BTT Octopus Pro directly connected at the PT100/PT1000 port (J47) running Klipper. This is From the measurement of the ADC pin, Klipper calculates the correct temperature and by default calculates with 4700 Ω. I'm using a PT1000 for the extruder and Generic 3950 for Also your Klipper settings seem to be correct now. The descriptions in this document are formatted so that it is possible to cut-and-paste them into a printer Klipper is a 3d-printer firmware. uaaq7px, 9tmrroc, vwap5fju, 2jlv, 1v9, 3g, vz5ei, gsi, g5, qjpacnb,